Sinumerik 810 T sub program

Results 1 to 2 of 2

Thread: Sinumerik 810 T sub program

  1. #1
    Registered Zielke's Avatar
    Join Date
    Apr 2011
    Location
    wesel
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default

    Hello everybody

    I am working on a Kern D20 CNC turning machine with Sinumerik 810T controller.
    The problem is that the subprogram doesn’t work anymore. Completely different coordinates are approached in the simulation – not the once that are in my program.
    I tried to process a wave ( 400mm long) with different diameters . Raw material 80mm, finished measure between 45mm and 75mm. I used a cycle that I got from the ‘support’ for the roughing.

    However measures of 200mm-80mm are being pre-roughed in the slope. The sub program runs correctly during the roughing process. I had to write the whole program in separate sentences.
    That worked but it’s not the way it should work when you have cycles.

    Funnily enough there were no problems with the roughing in the first tensioning.

    Regards



  2. #2
    hapo
    Guest

    Default

    When the simulation doesn’t show what you believe you programmed, then it’s not the machine’s or controller’s fault..
    In most cases the problem stands in front of the machine …wink.gif



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Sinumerik 810 T  sub program

Sinumerik 810 T  sub program