Anybody?
Thanks
Hi, I'm trying to determine which post processor I need for my plasma table. I'm using sheetcam, great product by the way. Following is a copy and paste of a simple NC file that I know works.
G70
G91
G00X2.500Y46.750
G41M15
F110.0
G01X0.000Y-0.500
G01X0.000Y-45.750
G01X-2.000Y0.000
G01X0.000Y45.750
G01X2.000Y0.000
G01X0.250Y0.000
M16G40
G00X2.500Y0.500
G41M15
G01X0.000Y-0.500
G01X0.000Y-45.750
G01X-2.000Y0.000
G01X0.000Y45.750
G01X2.000Y0.000
G01X0.250Y0.000
M16G40
G00X-5.500Y241.750
M00
G00X0.000Y-288.000
M02
The table has the following specs.
Koike - D7 Cutting Tips
Coordinate Drive Control System
Type: LYNX
System: 6D55181G04
Control/Amplifier: 6D55179G03
Thanks,
Tim
Similar Threads:
Anybody?
Thanks
twooten,
Les had posted in his yahoo group that he was going to be out of town for a few days. Probably isn't back yet and he is your best bet to help.
Art
AKA Country Bubba (Older Than Dirt)
Sorry for the delay. I have been on holiday. I've emailed you a post to try.
I also need a Post for this controller. Sorry to open an old thread but any help would be awesome.