- Homing questions about IO and sequence in the CNCUSB software
-
Member
Homing questions about IO and sequence in the CNCUSB software
I have installed my three axis limit switches and have attached them to limit input lugs on the MK3/4 board.
x on input 1
y on input 2
z on input 3
My sequence is set
z , x, y.
Can anyone tell me exactly what needs to be set in the software, in order for my setup to work properly?
Similar Threads:
-
-
Member
Re: Homing questions about IO and sequence in the CNCUSB software
- Homing questions about IO and sequence in the CNCUSB software
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules