Can anyone help? I've purchased a 5 axis controller board for a project but the axis labels read XN XD XS XE, YN YD YS YE and so on rather than XA+ XA- XB+ XB- etc. as I was expecting. Anyone what N D S E corresponds too? Thanks.
Hi, if the board you have is this one, this seller took the time to provide more information. If you don't get your answer from this drawing, try to get it by searching for 2m542 driver and controller. I hope this helps.
hi mundemp, i know its been a few years since your post but can i ask did you get an answer to this question as i have just bourght the same board and i am totally confused
thanks