- 5 axis configuration question
-
Registered
5 axis configuration question
I'm thinking of setting up a small mill like sherline or tiag with a trunnion table for 5 axis. (this is my understanding and was looking for clarifiction) Mach 3 to a smoothstepper handles 5 axis through dual parallel ports. Can I then hook one to a g540 and the othe port to a BOB to a g250 to get a 5 axis setup?
Similar Threads:
-
- 5 axis configuration question
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules