mt3 endmill holder 3/4"

[karbyde]

Anyone have one of these just sitting around? I am getting too lazy to swap tool bits and would like dedicated holders lol. I probably could use other sizes too but a 3/4" one would get the most use.

Similar Threads:

• Schunk CAT50 1.00" Hydraulic Coolant Through Endmill Holder 0203949
• Anyone Using A Tormach 17mm "Modular" Endmill with the "Medium" Adaptor?
• Looking for MT3 ER holder
• WTB: Erickson Type 419e / DA18 collet holder for MT3 taper
• 1/8" shank endmill holder

[mactec54]

Anyone have one of these just sitting around? I am getting too lazy to swap tool bits and would like dedicated holders lol. I probably could use other sizes too but a 3/4" one would get the most use.

You can get this from here https://www.shars.com/precision-end-...se-taper-3-3-4

[karbyde]

You can get this from here https://www.shars.com/precision-end-...se-taper-3-3-4

Shars seems to be among the cheapest for this style tool holder. Hoping to find someone here who did the R8 spindle upgrade and wishes to unload their used mt3 holders.