- collete upgrade to shoptask 1720
-
Member
collete upgrade to shoptask 1720
i hope this post helps someone.
i got tired of swapping out the mt3 tools on my 1720.
i decided to try and upgrade to a collet system.
none of the vendor out there seem to sell a kit.
i ended up winging it
as i so often do.
so i bought an er32 mt3 m12 cheap collet set off of amazon.
i then bought some m12 thread rod and an m12 nut for the drawbar.
i welded the nut to the bar..the nut is an 18mm serrated flange nut.
here are some pics
runout was .0012
no sure if thats good or not..im a novice..
Similar Threads:
-
-
Member
Re: collete upgrade to shoptask 1720
I picked up a similar set, but it's not answering the problem of short quill travel and working between short mills and longer drills and wigglers etc. Hard to work through a job without re-clamping the work at different heights.
Sent from my SM-G950U using Tapatalk
- collete upgrade to shoptask 1720
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules