I have mach 4 plasma with vital system arch pro screen with sheet cam the post processor that works is the mach 3 the others don't seam to work nether does the vital system one
my problem is I have en engraver in the plate marker tool I need to delite the M3 M5 command so it wont fire my torch with the spindle commands
I can disable it in mach because it take my THC off line when going from engrave to a plasma cut on the same layout im almost there
every thing works fine except torch fire win the plate marker tool using m3 m5
its not the engraver I have a problem with I have an out put programed with over ride switch on screen works fine in mach 4
I just need to remove the M3 M5 spindle on command in the plate marker tool. so it wont fire my torch
I cant switch it off because when I switch to the torch it has to work to make the torch cuts
every thing works fine except the spindle command in the plate maker I using a hilcon controller with the arch pro screen it uses the spindle on for torch control
if I change it ill have other tool problems wanting to use the m 3 m5 commands
the best way is I need a plate maker tool with no m3 m6 in it ill be good to go