Zero pierce time in Sheetcam?


Results 1 to 3 of 3

Thread: Zero pierce time in Sheetcam?

  1. #1
    Registered moccasin's Avatar
    Join Date
    Feb 2017
    Location
    United States
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Zero pierce time in Sheetcam?

    Maybe I'm missing something here but setting pierce time to 0 "zero" still leaves a short pause before the torch starts to travel. Is it possible to have no pause either before of after the cut? Just using the torch to etch.
    Thanks,
    MM

    Similar Threads:


  2. #2
    Registered
    Join Date
    Oct 2010
    Location
    USA
    Posts
    153
    Downloads
    0
    Uploads
    0

    Default Re: Zero pierce time in Sheetcam?

    If there is code to wait for the ARC-OK signal, this may add the time you are seeing.



  3. #3
    Registered
    Join Date
    May 2012
    Location
    Trinidad
    Posts
    23
    Downloads
    0
    Uploads
    0

    Default Re: Zero pierce time in Sheetcam?

    Not sure if you're using Mach, but could it not be your spindle on delay if you do? In Mach go to: Config > Ports and Pins > Spindle Setup > General Parameters. and set all to 0



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Zero pierce time in Sheetcam?

Zero pierce time in Sheetcam?

Zero pierce time in Sheetcam?