- tool magazine won't go forward
-
Member
tool magazine won't go forward
my machine has umbrella type tool changer, Fanuc 0iMD control
Yesterday, during tool change, the magazine did not fully forward due to leaking airhose.
after i changed the airhose, i power it off
today it refuses to go forward during M6
if I push the manual air button on solenoid valve, it works normally.
anyone had experienced such issue?
Similar Threads:
-
-
Registered
Re: tool magazine won't go forward
surely the problem is the sensors that identify if the carrucel this forward or backward.
-
Member
Re: tool magazine won't go forward
Hi josetarifa, thanks for reply.
I just solved the problem, it was loose cable at the terminal box near the ATC
Last edited by mcv; 07-02-2016 at 06:03 AM.
Reason: SOLVED
-
Registered
Re: tool magazine won't go forward
you're welcome
at your service
- tool magazine won't go forward
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules