NEED HELP SERVO ENGAGE


Results 1 to 2 of 2

Thread: NEED HELP SERVO ENGAGE

  1. #1
    Registered
    Join Date
    Feb 2006
    Location
    romania
    Posts
    35
    Downloads
    0
    Uploads
    0

    Unhappy NEED HELP SERVO ENGAGE

    hi
    i vave had my plasma table runing for 6 monts on belts
    and decided to go for rack & pinion drive. all worked fine until my servos do not engage anymore .
    I have a buton on my controller (logitroll 20 amp ametek servos )that if i push up for 3 sec it engages (activates ) the servos or from active mode if pushed down dectivates the servos.
    when my computer is of or if i unplug the parallel cable from computer ,i can activate the servos everything is ok
    but when the computer is on (does not mater if mach is runing or not)the servo do not engage.
    when i push the buton to activate the servos they try to move and deactivates
    or if i keep the buton presed the 3 axis move rapidly and get deactivatad and move again (hi speed very short moves ) and so on until i release the buton.
    there is another situation when i unplug the parallel cable, activate the servos then plug back the cable and play whit it lyke everything is ok

    Similar Threads:


  2. #2
    Registered
    Join Date
    Feb 2006
    Location
    romania
    Posts
    35
    Downloads
    0
    Uploads
    0

    Default

    the xml file

    Attached Files Attached Files


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

NEED HELP SERVO ENGAGE

NEED HELP SERVO ENGAGE

NEED HELP SERVO ENGAGE