I am adding a rotary to my FlashCut system. I am needing a Logosol drive # LS182. I read of a lot of people that changed from FlashCut to Mach3. I hope that someone may have one they are not using that they would sell. Thanks,
Mike
I'm not sure how old this post is but I have two of the 182-1210 and one 182D-1210 that I am not using at the moment. I am trying to figure out if I can plug my step and direction outputs from my smooth stepper into my flash cut servo driver box bypassing the signal generator in order to run mach3.