Reply with QuoteFriends, you can contact your purchaser. They should have a circuit diagram to check the circuit. They should also have the driving parameter settings and troubleshooting methods. Hope itcould help you.
CNC Router servo drive failiure
Initially the z axis servo drive would just randomly stop working and wouldn't turn on until i shut the machine down and wait awhile.
That used to be the main issue.
I then foolishly switched z axis servo drive in place of a y axis one and thats when the whole machine basically won't turn on anymore (even after switching them back in their original places).
When i hit restart button inside of Mach3 none of the drivers activate from sleep to run mode. You only hear a relay like on the video and drivers stay in sleep mode and you can only see bb on display the whole time.
Do you have any tips on what i can do to get the machine up and running again? Thanks.
Video:
Similar Threads:
- Encoder signal to servo drive & controller; split or through drive?
- Need Help!- MISSING AC SPINDLE DRIVE + 3 AXIS SERVO DRIVE
- New Machine Build- Servo Amp -vs- Drive question? Old Bandit 3 w/ MSI MM3-CCC--09 Servo drive/amp??
- Problem- old Mazak M2 Control on VQC Machining TRA-41 Servo Drive with HD101-12 DC axis drive
- Newbie- CNC Lathe - Servo direct drive or pulley drive?
Re: CNC Router servo drive failiure
Friends, you can contact your purchaser. They should have a circuit diagram to check the circuit. They should also have the driving parameter settings and troubleshooting methods. Hope itcould help you.
Re: CNC Router servo drive failiure
Did you pull out the cables while the motors were powered up? If so, you probably caused a spark which damaged your drives.
[FONT=Verdana]Andrew Werby[/FONT]
[URL="http://www.computersculpture.com/"]Website[/URL]
Posting Permissions
