Depends what section/devices are 3ph, it may be possible to use the vast majority of the M/C on 1ph.
What voltage 3ph is required?
Al.
hello, i purchased a used cnc router. then i realized it was 3 phase. i have regular 220. what's my cheapest solution? attached are the specs on the converter and spindle. thank you so much?
Depends what section/devices are 3ph, it may be possible to use the vast majority of the M/C on 1ph.
What voltage 3ph is required?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
220 3 phase
So if you have 220 1ph available, check to see what exactly requires 3 phase to run, most could be actually 1ph and just the spindle or any other aux motors could be 3ph.
If so you could obtain a VFD for the spindle.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.