Anyone have any thoughts as to weather or not these servos (if powered by a suitable PS https://www.automationtechnologiesin...vac-or-230vac/ ) will have the guts to move the 10EE carrage at rapid speeds over 100ipm?
I will be using ballscrews 5tpi, and either a 3 to 1 belt reduction or servo reducer.
This will be my second 10EE, and as it was an air tracer model, and missing some parts, I dont feel bad tearing down this 10EE for the conversion. My 1942 round dial will remain intact and original as my primary lathe.
Hope some of you will have the time to chime in and advise a bit on this conversion!