I'm receiving a spindle alarm on my Hurco Mill that has a Yaskawa 626VM3 servo drive.
The machine was turned off over the weekend. When I boot up the control The display on the drive has F-A00.
Please let me know what this alarm is and what can be done to correct it.
Similar Threads:
When the main power switch on the electrical panel is turned on the control boots up.
Then there's a green power on PB in the center of the pendant I push then the cycle start PB.
Then the machine would be fully powered up and ready to reference.
5 seconds after the power on and cycle start PBs are push is when the spindle alarm occurs.
Did you resolve this issue
Sent from my Moto G (5) Plus using Tapatalk
I have the same issue, so how did you fix the problem