INDRAMAT KDA 3.2-150-3-A00-W1

[Russell840]

Hi there

What I want to ask is about Spindle Drive, which is:
KDA 3.2 series.

when I connect the " Control Voltage Bus ( X1 pin assignment 16way bus ), unfortunately, the power unit stop output voltage( eliminate POK ) and nothing mirrors in the spindle drive.

also, I remove the 24-volt wire from Power control board( Inside of the spindle drive unit, Which I attached the picture in post) POK goes OK green and spindle drives Fault ( red LED) turns ON.

Does anybody have the same experience?
any help will be appreciated kindly.

With Regards
Russell

Similar Threads:

• Need Help!- M-parametrs Indramat 2AD
• Indramat TVD 1.2-15-03 no power
• indramat parts
• Indramat

[Russell840]

here is the 2nd connection, Gray & Green.