Hi there
I am trying to run a Delta 750 W servo motor, and delta ASDA-B2 Driver
I wired every thing and I get the AL.013 Code in the driver LED Display, apparently is the right Code,and it shows that my wiring are correct. But this is as far as I
could go, I simply have not been able to Run the Motor as of yet. Any recommendation is greatly appreciated. I think I must turn off the emergency or brake Code.
but the User manual is simply vague.
By the way my Controller is Mach3 Motion CARD ESS(Ethernet Smooth Stepper) HM-LAN-4Axis.
regards
jhonansaro
Similar Threads:
Last edited by johnansaro; 02-24-2018 at 03:47 PM.
Hi there
Does anybody have the List of parameters for the Delta ASDA-B2 driver with 750 W Motor? if you do, could you please provide the List.
Regards
jhonansaro
Hi there
How can I change or set the direction of moving my Delta asda b2 servo motor/drivers?
What is the parameter that i need to change, in order to change Cw, or CCw direction of my motor?
I searched the net, but It is very hard to get information on servo motors.
Regards
jhonansaro
Hi there
During the auto gain Tuning, my value of Inertia Ratio, which should be around value of 4, is a low value of .1 (off course after tuning process )
What could cause that?
What is exactly Inertia Ratio?
regards
jhonansaro
Solved no need to reply