- Alarm #410 tool change Matsuura 510V Yasnac MX3 - Need Help Please!!
-
Member
-
-
Member
Re: Alarm #410 tool change Matsuura 510V Yasnac MX3 - Need Help Please!!
Hello Dear Adbuch!
I'm asking for help! I have the same problem as yours with alarms # 410 and #445 with tool change from Matsuura with Yasnac MX3 (problem when changing the tool)! Were you able to solve the problem and how did you solve it? I checked everything and I'm already desperate. Video tool change:
Please help again!
I look forward to your reply.
Best regards
Iliyan
-
Member
Re: Alarm #410 tool change Matsuura 510V Yasnac MX3 - Need Help Please!!
Illyan,
something strange here. Spindle airblow happens at strange time.
Is the motor rotating CW?
Arm is at home when rear switch is over a milled square pocket.
rotate cam with spud on shaft, with tool in arm (no pull stud) when arm shaft moves in/out align arm with spindle by loosening power lok, then tighten power lok.
Brake is applied to motor by "plugging" (DC current is applied to motor winding from contactor) Sometimes this DC current will burn off contacts in contactor (MS7)
- Alarm #410 tool change Matsuura 510V Yasnac MX3 - Need Help Please!!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules