trouble with configure and testing R990H servo drive

Results 1 to 2 of 2

Thread: trouble with configure and testing R990H servo drive

  1. #1
    Registered
    Join Date
    Jan 2007
    Location
    Slovenia
    Posts
    93
    Downloads
    0
    Uploads
    0

    Unhappy trouble with configure and testing R990H servo drive

    In the document i insert pictures with messages i get when i use RT990H (DOS) and Rutex Tuner(Windows)
    I am not useing rutex motheboard but i wire it direct to parallel port .

    What to do?

    Similar Threads:
    Attached Files Attached Files


  2. #2
    Member
    Join Date
    Aug 2004
    Location
    US
    Posts
    2849
    Downloads
    0
    Uploads
    0

    Default

    So, there must be a signal (wire) that is used to indicate that a Rutex driver is connected.....or is the software interrogating the driver and it's responding , but your communication back to the computer is mis-wired? Look at the Rutex documentation....look for a driver sense line...



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

trouble with configure and testing R990H servo drive

trouble with configure and testing R990H servo drive