Use the Multimter to check if you get any 0-5V signal in Dir and Pul when you jog in Mach3
https://www.automationtechnologiesinc.com/
Hi
All 4 stepper motors stop suddenly working under Mach 3 on my main pc and even with my 2nd pc.
When I hit the x, y, z buttons on my pc Mach 3 is moving on the screen but the step motors are not working
As per attached picture, the rockcliff stepper driver card look powered, connections are good.
Do you have an idea of the problem and the solution
Thanks
Jack
Similar Threads:
Use the Multimter to check if you get any 0-5V signal in Dir and Pul when you jog in Mach3
https://www.automationtechnologiesinc.com/