- How to close this geometry?
-
Registered
-
-
Member
Re: How to close this geometry?
Place a point at the intersection of the guide curves you are trying to use and use the loft command. Chose the point and the open surface as your sections. Then tweak your ratios as required.
-
Member
Re: How to close this geometry?
You can also use the Dupedge (Duplicate Edges) command to create a curve for that open edge if you don't have it.
Split the resulting curve vertically using that vertical staple-looking line.
Then, use the CrvNetwork (Network Curve) command and select the three vertical lines, then the cross-section horizontal line, and it'll create a nice open surface that should match the tangency of the one you've got, there.
- How to close this geometry?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules