Need A Quote Need Flywheel turned 11"


Results 1 to 3 of 3

Thread: Need Flywheel turned 11"

  1. #1
    Member
    Join Date
    Dec 2007
    Location
    usa
    Posts
    341
    Downloads
    0
    Uploads
    0

    Default Need Flywheel turned 11"

    Need to have a fly wheel turned on outside diameter and rim edges two ( ea. ) # 60 surface finish, fly wheel approximate 11 inches casting ,bore HOLE FOR SLIDING FIT FOR .625 SHAFT also put in 1/4 20 setscrew hole for grub screw 15 degree angle thread not necessary.
    The set screw will be centered on the hub either side does not matter , all sizes are as they just clean up to remove casting flash ,clean up center hub, face both end's no clean up on the diameters of center hub.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Need Flywheel turned 11"-fly-wheel-jpg  


  2. #2
    Member
    Join Date
    Dec 2007
    Location
    usa
    Posts
    341
    Downloads
    0
    Uploads
    0

    Default Re: Need Flywheel turned 11"

    I have a drawing ,all machined surfaces just to clean up and finish cast iron 60 finish

    Attached Files Attached Files


  3. #3
    Member
    Join Date
    Dec 2007
    Location
    usa
    Posts
    341
    Downloads
    0
    Uploads
    0

    Default Re: Need Flywheel turned 11"

    The job has been filled .
    Thank you for to those who replied



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need Flywheel turned 11"

Need Flywheel turned 11"