Do you have a drawing of the item? You can send it to g28Machining@gmail.com.
Sent from my SM-G955U using Tapatalk
6061 Aluminun Bar
0.75" x 0.125" X 14"
Bar may be extruded with rounded corners on sides, or not, the side rounding is preferred, but not important.
Ends rounded at 0.045 radius on all 4 edges. No sharp edges on whole part.
I get a good finish on these using dish scrubbing pads, and would like a finish like that.
Tolerance 4 thou.
This is for a patent pending medical device. Very much like an Orthopedic. The final product is worn on the body presses against fabric, so I want to avoid damage from sharp corners.
Quantities to quote:
100
1000
5000
Similar Threads:
Do you have a drawing of the item? You can send it to g28Machining@gmail.com.
Sent from my SM-G955U using Tapatalk
PM sent...
Jimmy Bruno
www.stonewellbodies.com
PM sent
Thank You
Matthew Schindler
Micro Shaped
Matt@MicroShaped.com
Pm sent ...
Sent from my SM-J320R4 using Tapatalk
I have some changes to my quote.
This is not a high precision part. When in use, all sides will be touching foam padding, or fabric, so I just need the corners rounded as to not tear into the fabric. 0.045 radius, but 0.04 or 0.05 is ok too. Round all edges, and corners.
Quantities, lengths vary.
100 pieces:
20, 11"
20, 12"
20, 13"
20, 14"
20, 15"
1000 pieces:
200, 11"
200, 12"
200, 13"
200, 14"
200, 15"
10,000 pieces:
2000, 11"
2000, 12"
2000, 13"
2000, 14"
2000, 15"