Good morning,

I have a new laser with the TL 410C Controller.

After installing Autolaser, I began to make a cut, but it does two things:

1- 0,0 seems to be on the right side of the bed.
2- I get an out of range error.

I set the bed dimensions in autolaser, I am just trying to cut a small square for testing.

What do i do? Very frustrating, very little info on this online. I made a huge mistake getting this laser with this controller, but now i am stuck until i can figure out how to upgrade the controller with a AWC708C I have.


Similar Threads: