Need help!


Results 1 to 1 of 1

Thread: Need help!

  1. #1
    Registered
    Join Date
    Feb 2018
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Need help!

    Once our engraver is turned on, during the system reset, the laser moves to the top right corner (pictured) and hits both the back and the side rail. I have attempted to replace the limit senors, but to no avail. Not sure if it was a poor installation or a parameter issue or what. If you have any guidance please let me know. Thanks!

    Attached Thumbnails Attached Thumbnails Need help!-img_2624-jpg   Need help!-img_2623-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need help!

Need help!