- Solving Out of square axis
-
Member
Solving Out of square axis
Hello everyone, my 900x600 bed seems to be out of Square to the gantry as cutting 2 circles and placing them on top of each other gives different shapes. Can anyone direct me to a detail method of re-aligning the gantry so that’s it’s square to the x axis
thanks in advance
Similar Threads:
-
-
Member
Re: Solving Out of square axis
I think I would try cutting squares so it is easier to measure the exact amount of error. Measure the diagonals and you should be able to calculate how far to move to correct it.
I recently saw a large commercial duty machine and it had a mechanism to re-square the gantry. One end of the X axis has 2 hard stops that you bring the gantry towards when it is powered down. When both sides touch the hard stop, it is square or at least within a mil of being square. The stops had a screw to adjust the exact stop position, but that only needs to be set up once.
An alternative is to position sensors and use a routine that sneaks each side up to their sensor independently until both sides trip the sensor at the same time.
Steve
- Solving Out of square axis
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules