Open source P&P revolver head - Page 2

Page 2 of 2 FirstFirst 12
Results 21 to 23 of 23

Thread: Open source P&P revolver head

  1. #21
    Registered
    Join Date
    Jul 2011
    Location
    usa
    Posts
    214
    Downloads
    0
    Uploads
    0

    Default

    Further considering the costs of the linear guides, they are actually only required for the z-axis. If you keep the segments seated with conical pins at the wheel with spring force and drive the segment down with a foot shaped guide, than you would require only one expensive linear guide.

    Attached Thumbnails Attached Thumbnails Open source P&P revolver head-revolve30-jpg   Open source P&P revolver head-revolve35-jpg  
    Last edited by stewi; 01-04-2012 at 08:51 AM. Reason: changed pic


  2. #22
    Registered
    Join Date
    Jul 2011
    Location
    usa
    Posts
    214
    Downloads
    0
    Uploads
    0

    Default

    oops, feet need to be wider, else the segments don't fit through the z-axis rods.

    Attached Thumbnails Attached Thumbnails Open source P&P revolver head-revolve36-jpg  


  3. #23
    Member
    Join Date
    Mar 2011
    Location
    Malaysia
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: Open source P&P revolver head

    Hi,

    actually i am confused in the vacuum distribution design.
    how it work actually?
    Possible to share me the detail?



Page 2 of 2 FirstFirst 12

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Open source P&P revolver head

Open source P&P revolver head