- Need Help!- PROCESSOR FOR MAZAK VERTICAL CENTER SMART 430A
-
Registered
PROCESSOR FOR MAZAK VERTICAL CENTER SMART 430A
Im looking for a POST PROCESSOR FOR MAZAK VERTICAL CENTER SMART 430A EIA/ISO programming to use in Vectric to save tool paths that support I j k arcs and circles to run on the Mazak 430A and that will save the file as a .EIA
Thanks all
Similar Threads:
-
-
-
Re: PROCESSOR FOR MAZAK VERTICAL CENTER SMART 430A
Open the PP that mostly works for you in notepad. Then replace some (or all) of the lines following the "begin header" line. For example, the following is the header section that I use for a Tormach under Pathpilot:
begin HEADER
"( [TP_FILENAME] )"
"( [DATE] - [TIME])"
"( Material Size)"
"( X= [XLENGTH], Y= [YLENGTH], Z= [ZLENGTH])"
"([FILE_NOTES])"
"(Tools in this file: )"
"([TOOLS_USED])"
"(Toolpaths in this file"
"([TOOLPATHS_OUTPUT])"
"[N]G00G20G17G90G40G49G80"
"[N]G91.1"
"[N](Position for tool change)"
"[N]G30"
"[N]T[T]M06"
"[N] (Tool: [TOOLNAME])"
"[N]G00G43[ZH]H[T]"
"[N](Mist coolant ON)"
"[N]M08"
"[N][S]M03"
"[N](Toolpath:- [TOOLPATH_NAME])"
"[N]([TOOLPATH_NOTES])"
"[N]G94"
"[N][XH][YH][F]"
Be certain to edit in NOTEPAD or similar program that doesn't add funny characters to your file (DO NOT USE WORD, FOR EXAMPLE)
- Need Help!- PROCESSOR FOR MAZAK VERTICAL CENTER SMART 430A
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules