Mastercam 2018 Post Processor for Fanuc 18i-WA

[FOliveira]

Good night everyone,

I am new in the Forum and might be doing this wrongly.

Already searched the forum for what I am looking for but it might be something very especific.

I have an Agie Charmilles Robofil 230 Wire EDM machine from year 2000 with an NC Fanuc 18i-WA.

Been using Mastercam 2018 to create my CAMs and I am using the "Generic Fanuc 4X Wire.pst" Post-Processor (in attachment), but noticed that some blocks are wrongly contructed and/or not constructed in the right order.

Also, when I try to produce a taper cut, the code applies the G51 inclination and the correct angle in the machine but it doesn't activate the M15 for the Taper Cut Mode (M15P=0,1,10 or 11) which is necessary, according to the books.

Can anyone suggest some alterations to this post-processor or already had the same problems?


Glad for all your help,

Best Regards,

Filipe Oliveira