Mastercam 2018 Post Processor for Fanuc 18i-WA

Results 1 to 1 of 1

Thread: Mastercam 2018 Post Processor for Fanuc 18i-WA

  1. #1
    FOliveira's Avatar
    Join Date
    Dec 2018
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Mastercam 2018 Post Processor for Fanuc 18i-WA

    Good night everyone,

    I am new in the Forum and might be doing this wrongly.

    Already searched the forum for what I am looking for but it might be something very especific.

    I have an Agie Charmilles Robofil 230 Wire EDM machine from year 2000 with an NC Fanuc 18i-WA.

    Been using Mastercam 2018 to create my CAMs and I am using the "Generic Fanuc 4X Wire.pst" Post-Processor (in attachment), but noticed that some blocks are wrongly contructed and/or not constructed in the right order.

    Also, when I try to produce a taper cut, the code applies the G51 inclination and the correct angle in the machine but it doesn't activate the M15 for the Taper Cut Mode (M15P=0,1,10 or 11) which is necessary, according to the books.

    Can anyone suggest some alterations to this post-processor or already had the same problems?


    Glad for all your help,

    Best Regards,

    Filipe Oliveira

    Attached Files Attached Files


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Mastercam 2018 Post Processor for Fanuc 18i-WA

Mastercam 2018 Post Processor for Fanuc 18i-WA