[COLOR=var(--always-white)][COLOR=var(--primary-text)]Hello everyone over the last year or so we have been retrofitting our plasmacam 4x4 table from proprietary hardware to ess and tmc running mach 4 we were able to get the table to run a gcode and to come down and touch off the plate and it will go up to the set pierce height but the problem we are running into is that the torch will dive into the plate after a short time and we are confused as to why. If anyone here could help us out it would be very much appreciated we are new into all the DIY cnc setups.
the software we are using is mach 4 for the table control and sheetcam for the gcode and post process




[/COLOR]

[/COLOR]


















Similar Threads: