Need help connecting my hypertherm to plasmacam


Results 1 to 2 of 2

Thread: Need help connecting my hypertherm to plasmacam

  1. #1
    Registered Rcaugh's Avatar
    Join Date
    Jan 2019
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Need help connecting my hypertherm to plasmacam

    I recently bought a cpc port and a plug n’ play cord from pj metal fab for connecting my hypertherm powermax 85 to the dhc2 model that plasmacam makes. I have zip tied the trigger open, and also test fired it before strapping it in the mechine. I can’t seem to get the controller to fire the torch and it will only move x, y, and z directions tracing out the pattern from the computer. I need help figuring out the wiring. I have the onboard voltage divider set to 20.1-1. Thanks!

    Similar Threads:


  2. #2
    Registered
    Join Date
    Nov 2010
    Location
    USA
    Posts
    118
    Downloads
    0
    Uploads
    0

    Default Re: Need help connecting my hypertherm to plasmacam

    Hi, give me a call and maybe I can get you cutting.

    Joe

    270-776-4042



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need help connecting my hypertherm to plasmacam

Need help connecting my hypertherm to plasmacam