Settings/Input/Output/EStop Pin -> Enable
Hi,
i finally got my emergency stop-switch which i wired right to the E-Stop-Input on the MK3/4 Board and the ground. But nothing happens. What do i have to configure in the TNG to use it? I wired it up as Input and configured a shortcut - it works. But i got an extra E-Stop-Inlet and want to use it. But how?
Similar Threads:
Settings/Input/Output/EStop Pin -> Enable
Thanks, that was an easy one.
Advising the system that an E-stop occurred and relying on the S/W system to implement an E-stop is not enough in itself.
Technically you should have a hard stop also that immediately removes all power to motive devices, i.e. the power to all servo's and motors, spindles etc, should be opened.
This according to NFPA79 reg's.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.