Power supply

[Clyde_IT]

Another question:
With new OptoIso limit and input adapter I've all to 24VDC (including MK3 main board, adapter ecc.) except Output board for spindle control, is correct?
It's not possible solve this discrepancy?

Similar Threads:

• NEED HELP! New Pwr supply connection Leetro 6515 to RECI power supply
• Rebuild Hurco Power Supply w/ PC Power Supply VMX30
• Need Help!- Power Supply/Power Cord Sizing for Four 850 oz-in Servos, One is Slaved
• Power Supply from a computer power supply

[PlanetCNC]

I suggest you use 12V for everything if possible. It is more efficient than 24V.

[Clyde_IT]

Ah, ok, so I need two separate PSU.
I was hoping one would be enough, for to simplify my work
Thank's

C.

[PlanetCNC]

It is recommended that controller uses its own power supply.

[Clyde_IT]

ok, thank's again