Two Motors and Endstops on one Axes

[Macwolf]

I would like to use 2 motors and 2 end stops on the Y-axis on my portal milling machine. my board is the MK3/9 with current firmware, how do I define these two motors including endstops in the settings? and how are the endstops used in homing using both.
thanks Markus

Similar Threads:

• Need Help!- I'm experiencing binding along my table axes, causing motors to stall/lose steps
• Need help - two slave axes of two main axes?
• RESOLVED! Mach3 MaxNC enabled = 1/4 speed motors , Disabled = no running motors.
• Need Help!- Stepper motors on all axes twitches every 2 seconds.
• Belt Drive Gantry with STATIONARY motors for X and Y Axes

[mactec54]

I would like to use 2 motors and 2 end stops on the Y-axis on my portal milling machine. my board is the MK3/9 with current firmware, how do I define these two motors including endstops in the settings? and how are the endstops used in homing using both.
thanks Markus

No one should ever use end stops to home a machine, this puts unnecessary stress on the mechanical parts of the machine, Homing is normally done with a proximity switch or a Relay a proximity switch being the best choice

[Macwolf]

the end stops used are inductive proximity switches, the question is how are the 2 motors addressed separately when homing?

[mactec54]

the end stops used are inductive proximity switches, the question is how are the 2 motors addressed separately when homing?

There is normally a Homing routine that different controls use, which will home each switch separately, Proximity switches are not end stops, they are either a home switches or a limit switch's which also can do both, check with your control manual most controls have software that have homing routines for master and slave motors

[Macwolf]

PLEASE NOTE: Before using the gantry square method, the user must configure the master and slave motor outputs and their corresponding limit switch inputs.

Master slave axes have the same designation (Y) but how is it possible to assign this one axis to 2 limits? or do I have a misconception? if master (Y) and slave (other) then 2 limits are possible. as I said, how is this configured in TNG2?

[PlanetCNC]

During gantry square routine motors are assigned letters U and V. Therefore you need to set limit switches for U and V.

[Macwolf]

every homeming doesn't work? is another profile needed just for alignment?

[Macwolf]

it works after aligning the portal. thanks