You can make a simple splitter. Something like this:
https://planet-cnc.com/product/split...put-connector/
Hi everyone,
I've a question: I've a MK3 board and I've bought a Output board for my spindle, and there are on it, more the PWM signal, three relè output.
How I can use the other output of the board? (I lost 4 outputs, in this way)
The same for the Adapter for limit switch: there are on the board 4 input, and the other 4?
(There are in total 8 inputs and 8 inputs on MK3 board, and only 4outputs and 4 inputs on the additional board...)
Thank's in advance
Nino
Similar Threads:
You can make a simple splitter. Something like this:
https://planet-cnc.com/product/split...put-connector/
Ok, thank's.
The same is for Adapter limit switch board?
I have to buy another output board o I can use directly the output of the main board?
Also, I must another Adapter limit board or I can use directy the other input from the main board?
Nino
You can use inputs/outputs directly from main board. Just make sure you don't draw more than 20mA from outputs. And optoisolation is highly recommended for inputs.
ok, thank's again
Nino