Problems whit the error pin.

[tantemay]

New motor drivers, new problems with the alarm signal / error pin.
Hello.
I have four drivers on my MK3 / 9 controller.
I use the ALM signals. With the old drivers everything was as it should.
When a motor went into alarm, the EStop was activated.

Now with the new drivers, the CL57Y only works as long as no more than two drivers are connected.
I also tried "Normally Closed", but the ALM signal from the driver is ignored by the error pin.
I've tested all drivers, I've checked all cables. I checked the driver settings several times and also changed them to test.

So alo my question, what am I doing wrong.

Similar Threads:

• One thing I don't understand about the error pin.
• Need Help!- Problems on VM17 192 error and problems finding home.
• Need Help!- error: Extruder.hal:87: parameter or pin 'stepgen.6.position-scale' not found
• Need Help!- Problems whit angular head
• Problem- Problems whit feeds and Speeds

[PlanetCNC]

How are alarm signals connected? My guess is that you connected open collector signal in parallel.

[tantemay]

I've tried both variants. I have now switched to NC and optocoupler. Now it works.