- Problems whit the error pin.
-
Member
Problems whit the error pin.
New motor drivers, new problems with the alarm signal / error pin.
Hello.
I have four drivers on my MK3 / 9 controller.
I use the ALM signals. With the old drivers everything was as it should.
When a motor went into alarm, the EStop was activated.
Now with the new drivers, the CL57Y only works as long as no more than two drivers are connected.
I also tried "Normally Closed", but the ALM signal from the driver is ignored by the error pin.
I've tested all drivers, I've checked all cables. I checked the driver settings several times and also changed them to test.
So alo my question, what am I doing wrong.
Similar Threads:
-
-
Member
Re: Problems whit the error pin.
How are alarm signals connected? My guess is that you connected open collector signal in parallel.
-
Member
Re: Problems whit the error pin.
I've tried both variants. I have now switched to NC and optocoupler. Now it works.
- Problems whit the error pin.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules