- PWM to 0-10v Signal?
-
Member
PWM to 0-10v Signal?
https://www.ebay.de/itm/PWM-to-Voltage-Converter-Module-0-to-100-0-to-10V-for-Digital-to-Analog-Signal/383873697260?hash=item5960a7c5ec:g:iaMAAOSwmyNf5Fy R
Hi there.
Is it possible to use this part with TNG for spindle speed control?
I can not find a setting that allows a reliable speed to be set.
Yes, I also have the Planet-CNC output board. But I don't want to use that because of the relays.
Which settings do I have to make in TNG so that it works?
Similar Threads:
-
-
Member
Re: PWM to 0-10v Signal?
It shoud work, just make supply with 12V or more, I have similar diy unit.
When adjusting be sure that won't go over 10V!
-
Member
Re: PWM to 0-10v Signal?
The volts checked. 10v for s24000 and 0v for s6000 but in between e.g. with the s12000 the actual speed differs significantly. What settings have you made?
-
Member
Re: PWM to 0-10v Signal?
u shoud check the adjustemnt in spindle driwer regarding manual. It can difer from firm to firm and type of the driwer...
Moastly always differs ....
Some of them have a possybility to add rpm back loop but not all...my, don't
I have to convert rpm to frquency (that is on display) and back to come out with app. rpm - quite annoying, hmmm
And check the lowest rpm alowed ! (my is 8000) It also differs.
-
Member
Re: PWM to 0-10v Signal?
The frequency converter is set correctly. I need the right settings in TNG.
-
Member
Re: PWM to 0-10v Signal?
My settings are:
CW = 5
CCW= 7
output pin = 6, min 1200 max 24000
start delay 6s, end 0,
use frequency = yes
min 0, max 1500Hz,
wide 0 us
rest is defoult, empty
hope it will help...
- PWM to 0-10v Signal?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules