How to disable M62
I have a MK2 controller on my CNC router. I am in the process of adding a laser to it. I need a 15-sec delay at spindle start for the bit to spin up, but I do not want a delay when I use the laser. If I use M62 to fire the laser, how do I turn it back off? Is there a better way to do this?
Similar Threads:
Re: How to disable M62
In the settings you can set how long you wait after a spindle start.
Otherwise, I don't know if the TNG v2 software can do that, but give it a try.
M62 Turn on digital output synched with motion
M63 Turn off digital output synched with motion
M64 Turn on digital output immediately
M65 Turn off digital output immediately
Thanks, I didn't think I could run TNG with a MK2 board. I'll have to try this with a demo installation...Originally Posted by tantemay
Re: How to disable M62
Mk2 will not work with TNG.
You can use M62 to turn output on and off.
Reply with Quote
