Which part of controller got wet?
Hi everyone, I have a problem with my mk3 controller board. All of it's input/output had noised after getting wet during operation.
This link below show exactly what going on with it. Can you give me some advise?
Similar Threads:
Which part of controller got wet?
Was it just water or something else? If the liquid contained any salts you may be out of luck. I believe the boards are conformally coated but even that is not always waterproof.
Did you try to bake the board at, lets say, 70 degrees C for a while? There may be some liquid hiding under the chips that takes longer to dry out.
It might need some compressed air around it to shift any remaining moisture.