- Manual tool change TNG v2
-
Member
Manual tool change TNG v2
Manual tool change TNG v2 Hello. Is it possible to make a manual tool change.
With my old control it worked without any problems. The machine paused using g-code. Then you could change the milling cutter and zero the Z axis again on the Wersrück surface.
TNGv2 is now also on pause but I can not move the axes. If I stop, the position in the g-code is lost.
Are there any g-code commands I can insert so that it works as described above. After restarting, the machine should start at the point at which it stopped.
Of course I know the method with "start at selected line", but this is risky for long programs.
Similar Threads:
Last edited by tantemay; 01-03-2020 at 09:57 AM.
-
-
Member
Re: Manual tool change TNG v2
In TNGv2 you can move machine when it is waiting on pause G-code. You can use jog it or use MDI.
Previous TNG versions offered much less.
-
Member
Re: Manual tool change TNG v2
From which version? Because that is exactly not working. After the M1 command, the machine stops and pauses, but then cannot be moved.
Edit: OK, now it works. I entered the M1 via MDI and it didn't work. If the M1 command comes in the G code it works.
Thank You!
Last edited by tantemay; 01-03-2020 at 11:41 AM.
-
Member
- Manual tool change TNG v2
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules