PostProcessors Vectric

[mar_cone]

Hi,
I tried the PostProcessors for Vectric inserted in the 20/12 version of TNG but I get an error; I use Aspire 9.0.
I tried to understand more by reading the Post Processor Guide attached to Aspire but without result :-(




Similar Threads:

• postprocessors
• Postprocessors
• Postprocessors
• Postprocessors?

[PlanetCNC]

This variable works in Aspire 10. You can safely comment or delete it.

[mar_cone]

Grazie.
In effetti, questa guida non ha fatto menzione di questa variabile; Avevo pensato di eliminarlo ma non ne ero sicuro.

[Anriro]

What is the name of the postprocessor for the vectric?
USBCNC?

[mar_cone]

C: \ Programmi \ PlanetCNC \ Samples \ Postprocessors \ Vectric

PlanetCNC_inch.pp
PlanetCNC_mm.pp

[Anriro]

OK

I don’t understand how to delete a message. Stupid site, the first time I see this.

[PlanetCNC]

Postprocessors for Vectric are included with TNG software. They are in Samples/Postprocessors folder.

[Deklos]

Hello,

I will re-use this topic for issue reporting. I was trying to use this script in Vectric 6 PRO. So I have copied PlanetCNC_mm.pp into C:/ProgramData/Vectric/VCarve Pro/V6.0/PostP/.

During starting there are multiple errors showed.

+VAR DWELL_TIME = [DWELL|A|P|1.2]

After commented this out it showed next error.

+VAR INVERSE_TIME = [FI|A| F|1.2]

Last comment and next error.

+begin DWELL_MOVE

+"G04 [DWELL]"

After last comment, Vectric started-up successfully. So what is the right way to use this? I am not really sure if can make this or not.

Thank you

[PlanetCNC]

I guess VCarve6 is too old and does not support these variables.

[Deklos]

I guess VCarve6 is too old and does not support these variables.

Thank you, so what is the min supported version?

[Deklos]

Thank you, so what is the min supported version?

I have verified, that output from Aspire 9 and my commented code are the same.