- TGNv2 and the Output Board. Settings: Spindle 0-10V
-
Member
TGNv2 and the Output Board. Settings: Spindle 0-10V
I would like to speed up the spindle speed via output board with a 0-10v signal.
What should I tick in the TNGv2? PWM ?, Frequens ?, RC?
Similar Threads:
-
-
Member
Re: TGNv2 and the Output Board. Settings: Spindle 0-10V
Frequency, 1500Hz, 0 step width
-
Member
Re: TGNv2 and the Output Board. Settings: Spindle 0-10V
I feel a bit fooled.
At frequency I can enter Max. and Min.,frequency and the Step With.
For PWM, I can specify the frequency but not the step with.
So, I ask again for the settings for a 400hz spindle with 3,000 RPM @ 50hz
The inverter is correctly configured, which was previously synonymous with the 10v signal, easily.
Last edited by tantemay; 11-29-2019 at 12:42 PM.
-
Member
Re: TGNv2 and the Output Board. Settings: Spindle 0-10V
Settings for our output board are:
Use Frequency = checked
Freq Min = 0
Freq Max = 1500
Step Width = 0
-
Member
Re: TGNv2 and the Output Board. Settings: Spindle 0-10V
- TGNv2 and the Output Board. Settings: Spindle 0-10V
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules