- Inductive Sensor
-
Member
Inductive Sensor
How to use the induction sensor for PlanetCNC? For inputs LIM and INX?
The sensor does not work like a normal contact, it passes voltage through itself from the power source.
I am afraid that this voltage will damage the board.(
)
I need a wiring diagram with explanations.
Similar Threads:
-
-
Member
Re: Inductive Sensor
-
Member
Re: Inductive Sensor
With different controllers, I've applied 12v directly from power source, and used resistor on signal wire to drop voltage to 5v. I plan to do the same with my PlanetCNC setup.
- Inductive Sensor
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules