TNGv2 Spindle button problem

Results 1 to 4 of 4

Thread: TNGv2 Spindle button problem

  1. #1
    Member theRat's Avatar
    Join Date
    Jun 2017
    Location
    Australia
    Posts
    67
    Downloads
    0
    Uploads
    0

    Default TNGv2 Spindle button problem

    If you are using scripts to manage M3, M4 and M5 and aren't using any of the on board outputs (my spindle is controlled using an I2C board), so under Settings-Spindle all the output pins are set to ---. When you click the spindle toolbar button or run M3/M4 the spindle state doesn't change (ie. not highlighted). When you click the button again rather that running the M5 script it runs the M3 script again.

    Cheers
    Simon

    Similar Threads:


  2. #2
    Moderator PlanetCNC's Avatar
    Join Date
    Mar 2017
    Location
    Slovenia
    Posts
    466
    Downloads
    0
    Uploads
    0

    Default Re: TNGv2 Spindle button problem

    Spindle (and Mist, Flood) state is tied to output pin. I'll check what I can do.



  3. #3
    Moderator PlanetCNC's Avatar
    Join Date
    Mar 2017
    Location
    Slovenia
    Posts
    466
    Downloads
    0
    Uploads
    0

    Default Re: TNGv2 Spindle button problem

    I'm working on this issue right now. Next release should have this resolved.



  4. #4
    Member theRat's Avatar
    Join Date
    Jun 2017
    Location
    Australia
    Posts
    67
    Downloads
    0
    Uploads
    0

    Default Re: TNGv2 Spindle button problem

    Thank you. I will test it for you when released. Thanks for all the great work.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

TNGv2 Spindle button problem

TNGv2 Spindle button problem

TNGv2 Spindle button problem