- TNGv2 Spindle button problem
-
Member
TNGv2 Spindle button problem
If you are using scripts to manage M3, M4 and M5 and aren't using any of the on board outputs (my spindle is controlled using an I2C board), so under Settings-Spindle all the output pins are set to ---. When you click the spindle toolbar button or run M3/M4 the spindle state doesn't change (ie. not highlighted). When you click the button again rather that running the M5 script it runs the M3 script again.
Cheers
Simon
Similar Threads:
-
-
Member
Re: TNGv2 Spindle button problem
Spindle (and Mist, Flood) state is tied to output pin. I'll check what I can do.
-
Member
Re: TNGv2 Spindle button problem
I'm working on this issue right now. Next release should have this resolved.
-
Member
Re: TNGv2 Spindle button problem
Thank you. I will test it for you when released. Thanks for all the great work.
- TNGv2 Spindle button problem
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules