- Is MK3 a “drop in” replacement for MK1?
-
Registered
Is MK3 a “drop in” replacement for MK1?
I have a MK1 board that I would like to replace with the MK3/4. It is running a small cnc engraver/router. Can I use all the other boards with the MK3?
Also, does the board include the PlanetCNC TNG license or do I have to buy that separately?
Thanks, Paul
Similar Threads:
-
-
Member
Re: Is MK3 a “drop in” replacement for MK1?
What do you mean with "all other boards "? Do you use such engraver? https://planet-cnc.com/replacing-chi...rv-controller/
License is a separate purchase and it is not included with controller.
-
Registered
Re: Is MK3 a “drop in” replacement for MK1?
Hi Planet, the controller in your link is exactly the one I have!
So, I can replace the Chinese junk with your MK3. But, I also have to buy the TNG license? Will your MK3 board work with LinuxCNC?
-
Member
Re: Is MK3 a “drop in” replacement for MK1?
TNG is software.
MK3 board series is hardware.
Both are required to work.
If somehow you break the MK3 hardware, then you just purchase the hardware again, not the software.
-
Registered
Re: Is MK3 a “drop in” replacement for MK1?
Thank you PlanetCNC and harryn.
Planet, yes, that is the unit i have. I want to take out the MK1 clone and replace it with your MK3/4 but keep the other boards (stepper drivers and power supply?).
Paul
-
Member
Re: Is MK3 a “drop in” replacement for MK1?
Sure you can keep the PSU and stepper drivers. Would you mind posting some photos of your stepper drivers and PSU?
- Is MK3 a “drop in” replacement for MK1?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules