- MK3/4 to PoStep60
-
MK3/4 to PoStep60
I am a complete Newbie - have built a CNC from scrapped parts...total Frankenstein.
2 questions on Stepper Motor control.
1 - when the machine is at rest, at odd times, the motors sound as if they are moving - without movement. Is the controller having issues sending a consistent "hold" voltage?
2 - I have already slowed my inches/minute considerably so as to not get the shudder in the stepper with loss of position. Is this a throughput Hz issue? I am only managing 25 ipm with 20400 steps per unit. It may be that my gearing too far to the power side and is not allowing a high ipm???
Thanks for your help!!
Randy
Similar Threads:
-
-
Member
Re: MK3/4 to PoStep60
1. this is caused by drivers, it is not harmful.
2. do yo have a gearing ratio on all of your axes?
Please contact support@planet-cnc.com , where we will continue this matter
- MK3/4 to PoStep60
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules